9G001D - Medium Duty Gate with Side Panel

Application

A Chubb Locks Custodial Services Ltd medium duty single barred grille gate traditionally used in Armed Forces barracks. The design was taken from previous versions of the Police Buildings Custody Design Guide and Court Standards & Design Guide.

Specification

Specifications, Performance Data & Tolerances

  • 150mm Max Centres 20mm dia Bars
  • 470mm Max Centres 50x25x3mm Rolled Hollow Steel Horizontal Frame Sections

Gate Leaf

  • 50x25x3mm Rolled Hollow Steel Section Frame & Horizontals to BS EN 10025:2004
  • 20mm diameter Steel Vertical Bars to BS EN 10025:2004
  • Bars Continuously Welded at Each Intersection
  • All Steelwork Shot Blasted to BS EN ISO 11124-4:1997
  • Steel Fabrication to BS EN ISO 9001: 2000
  • Welding to BS EN 1011-2: 2001
  • Anti-Spring Horns Welded to Hinge Side of Gate to Prevent Unauthorised 'Springing' of Lock
  • Gate Leading Edge to Have Anti-Lift Horn to Prevent Unauthorised lifting from Bottom Hinge Socket
  • Outer Steel Lock Box Continuously Welded into Gate leaf
  • Type 2 Chubb 3G112 Heavy Duty Mortice Lock Operable Both Sides
  • Welded Steel Lock Shroud to Protect Lock Bolt

Side Panel

  • 50x25x3mm Rolled Hollow Steel Section Frame & Horizontals to BS EN 10025:2004
  • 20mm diameter Steel Vertical Bars to BS EN 10025:2004
  • 65x50x6mm Rolled Steel Slam Angle to BS EN 10025:2004
  • Preparation for Lock Bolt with Welded Back Box
  • Bars Continuously Welded at Each Intersection
  • 65x12 Flat Steel Sections Joined to Form Slam Angle to BS EN 10025:2004
  • Machined Solid Steel Lock Bolt Receiver
  • All Steelwork Shot Blasted to BS EN ISO 11124-4:1997
  • Steel Fabrication to BS EN ISO 9001: 2000
  • Welding to BS EN 1011-2: 2001
  • Anti-Spring Horns Welded to Wall Side of Side Panel to Prevent Unauthorised 'Springing' of Lock
  • 6mm thick Top & Bottom Fixing Plates to BS EN 10025:2004
  • Floor & Head Fixings Hilti HSL-TZ M8/20 Sleeve Anchors

Hinges

  • 90 degree Opening Top & Bottom Pivot Hinges
  • Bottom Hinge Ball Bearing Mounted Cast Into Floor
  • All Welds Continuous
  • Top Hinge Pin Socket Welded to Header Rail
  • Top Hinge Pin Bracketed to Wall via Header Rail & Fixed with 3no. Hilti HSL-TZ M8/20 Sleeve Anchors

Standard Dimensions

  • Structural Opening 2100mm Wide x 2100mm High
  • Gate Leaf 1038mm Wide x 1875mm High Excluding Hinge(s) x 50mm Thick
  • Gate Leaf Clearance 6mm Leading Edge to Slam Angle, 75mm hinge, 75mm head/25mm Header Rail/50mm Clearance Over, 75mm undercut
  • Side Panel 900mm Wide x 2025mm High from FFL
  • Side Panel Clearance to Jamb 75mm

 

Finish

  • Powder Coat Epoxy Primer to BS EN 12206-1:2004

Standards